Yaskawa JAPMC-MC2300 - Manual (Page 37)

2.4 SVA-01 Module Connections
2.4.2 Connection Procedure for 24-V Input Cable
2-11
2
Settings and Installation
2.4.2 Connection Procedure for 24-V Input Cable
Prepare a 0.2 mm 2 to 0.51 mm 2 (AWG24 to AWG20) twisted-pair cable. Use the following connection procedure.
1. Remove the sheath to approximately 6.5 mm from the cable end.
2.
Remove the plug from the CN3 connector on the SVA-01 Module.
3.
Insert the bare core of the cable into the opening of the plug and then tighten the secrews to a tighten-
ing torque of approximately 0.2 to 0.25 N x m.
Pin No.
Signal
Name
Name
2 24V +24 VDC input
1 0V 0V
Core
Sheath
6.5 mm
+ side (pin number 2)
− side (pin number 1)