Get_write_data_phase() – Altera Mentor Verification IP Altera Edition AMBA AXI3/4TM User Manual
Page 474
Mentor VIP AE AXI3/4 User Guide, V10.2b
454
VHDL AXI3 and AXI4 Slave BFMs
get_write_data_phase()
September 2013
get_write_data_phase()
This blocking procedure gets a write data phase that is uniquely identified by the transaction_id
argument previously created by the
procedure. It sets the
data_beat_done array index element to 1 when the phase completes. If this is the last data phase
of the burst, then it returns the last argument set to 1.
Note
For AXI3 the get_write_data_phase() also sets the WREADY protocol signal at the
appropriate time defined by the transaction record data_ready_delay array index element
when the phase completes.
Prototype
-- * = axi| axi4
-- ** = AXI | AXI4
procedure get_write_data_phase
(
transaction_id : in integer;
index : in integer; --optional
last : out integer;
bfm_id : in integer;
path_id : in *_path_t; --optional
signal tr_if : inout *_vhd_if_struct_t
);
Arguments
transaction_id
Transaction identifier. Refer to
on page 203 for more details.
index
(Optional) Data phase (beat) number.
last
Last data phase (beat) of the burst:
0 = data burst not complete
1 = data burst complete
bfm_id
BFM identifier. Refer to
“Overloaded Procedure Common Arguments”
on page 203 for more details.
path_id
(Optional) Parallel process path identifier:
**_PATH_0
**_PATH_1
**_PATH_2
**_PATH_3
**_PATH_4
“Overloaded Procedure Common Arguments”
on page 203 for
more details.
tr_if
Transaction signal interface. Refer to
on page 203 for more details.
Returns
last