AASTRA 6700i series, 9143, 9480i, 9480i CT SIP Administrator Guide EN User Manual
Page 109
3-22
41-001343-01 Rev 03, Release 3.2.2
Switch Focus to Ringing
Line
Note: This option can
be set by both Users
and Administrators.
switch focus to ringing
line
Enables or disables whether or not the UI focus is switched to a
ringing line while the phone is in the connected state.
For more information on this feature, see
on
.
Call Hold Reminder
During Active Calls
Note: This option can
be set by both Users
and Administrators.
call hold reminder during
active calls
Enables or disables the ability for the phone to initiate a continuous
reminder tone on the active call when another call is on hold. When
this feature is disabled, a ring splash is heard when the active call
hangs up and there is still a call on hold.
For more information on this feature, see
.
Call Hold Reminder
Note: This option can
be set by both Users
and Administrators.
call hold reminder
Enables or disables the reminder ring splash timer to start as soon
as you put a call on hold (even when no other calls are active on the
phone). When enabled, the phone initiates a reminder ring splash
periodically for the single call on hold. When disabled, no reminder
ring splash is audible.
For more information on this feature, see
on
call hold reminder timer
Note: This option can be
set by an Administrator
only.
Specifies the time delay, in seconds, that a ring splash is heard on an
active call when another call was placed on hold. For example, if a
call comes into Line 1, and then a call comes into Line 2 and you
answer Line 2, Line 1 is automatically placed on hold. While on the
active Line 2, after 7 seconds, a ring splash audio sounds on the line
reminding you that the call on Line 1 is still on hold. This timer begins
to increment after Line 2 is answered.
Notes:
1. This parameter is used with the “call hold reminder frequency”
parameter.
2. You must enable this “call hold reminder timer” parameter for it to
work.
3. A value of “0” disables the call hold reminder feature.
For more information on this feature, see
.
call hold reminder
frequency
Note: This option can be
set by an Administrator
only.
Specifies the time interval, in seconds, between each ring splash
sound on the active line. For example, if a call comes into Line 1,
and then a call comes into Line 2 and you answer Line 2, Line 1 is
automatically placed on hold. While on the active Line 2, after 7
seconds, a ring splash audio sounds on the line reminding you that
the call on Line 1 is still on hold (determined by the “call hold
reminder timer” parameter), and then the ring splash is heard again
after 60 seconds (determined by this parameter).
Notes:
1. You must enable the “call hold reminder” and/or “call hold
reminder during active calls” parameter(s), and the “call hold
reminder timer” parameter, for this parameter to work.
2. A value of “0” prevents additional rings.
For more information on this feature, see
.
Parameter in
Aastra Web UI
Parameter in
Configuration Files
Description