AASTRA 6700i series, 9143, 9480i, 9480i CT SIP Administrator Guide EN - Manual (Page 763)

A-32 41-001343-01 Rev 03, Release 3.2.2
Rport Setting
Parameter –
sip nat rtp port
NAT RTP Port
(in Phone UI and Web UI)
IP Phone UI Options->Administrator Menu->
SIP Settings->RTP Port Base
Aastra Web UI Advanced Settings->Network->
Advanced Network Settings
Configuration Files aastra.cfg, <model>.cfg, <mac>.cfg
Description Indicates the port through which the RTP packets are sent. This value
must specify the beginning of the RTP port range on the gateway or
router.
The RTP port is used for sending DTMF tones and for the audio stream.
Your network administrator may close some ports for security reasons.
You may want to use this parameter to send RTP data using a different
port.
Note: The phones support decoding and playing out DTMF tones sent
in SIP INFO requests. The following DTMF tones are supported:
•
Support signals 0-9, #, *
• Support durations up to 5 seconds
Format Integer
Default Value 51720
Range Not Applicable
Example sip nat rtp port: 51730
Parameter –
sip rport Aastra Web UI: Advanced Settings->Network->
Advanced Network Settings
Configuration Files aastra.cfg, <model>.cfg, <mac>.cfg
Description Allows you to enable (1) or disable (0) the use of Rport on the IP phone.
“Rport” in RFC 3581, allows a client to request that the server send the
response back to the source IP address and the port from which the
request came.
Note: Configuring the Rport parameter is recommened for clients
behind a Network Address Translation (NAT) or firewall.
Format Boolean
Default Value 0
Range 0 (disable)
1 (enable)
Example sip rport: 1