AASTRA 6700i series, 9143, 9480i, 9480i CT SIP Administrator Guide EN - Manual (Page 366)

41-001343-01 Rev 03, Release 3.2.2 5-89
Preferred Line and Preferred Line Timeout
An Administrator or User can define a preferred line as well as a preferred timeout. If a
preferred line is selected, after a call ends (incoming or outgoing), the display switches back to the
preferred line. Next time you go off-hook, you pickup on the preferred line. You can specify the
number of seconds it takes for the phone to switch back to the preferred line using the “preferred
timeout ” parameter.
An Administrator can configure the “preferred line” and the “preferred timeout” parameters
using the configuration files or the Aastra Web UI. A User can configure these parameters using
the Aastra Web UI only.
The following table provides the behavior of the preferred line focus feature with other features on
the phone.
Phone Feature Preferred Line Behavior
call return The phone switches back to the focused line immediately after
the call ends.
speeddial The line is already specified when the speeddial is created. The
phone switches back immediately after the call ends.
conference For incoming calls, the phone switches back immediately after
the call ends.
transfer For incoming or outgoing calls, the current behavior is that the
same line used to transfer the call does not change. For incoming
calls, the phone switches back immediately after the call
transfers.
blf The phone switches back immediately after the call ends.
park The phone switches back immediately after the call ends.
voicemail The phone switches back immediately after the call ends.
redial The phone switches back immediately after the call ends.
dialing For incomplete dialing on a non-preferred line, the focus does not
change if some digits are entered.
If no digits are entered or digits were cleared, the focus changes
to preferred line after the time out has passed without activities.
caller id If the "Switch UI Focus To Ringing Line" parameter is disabled,
the User is able to see the Caller ID when the phone switches the
focus to the ringing line.
factory default Factory default and recovery mode clears the "preferred line" and
"preferred line timeout" parameters, and the phone operates in a
non-preferred line mode.