AASTRA 6700i series, 9143, 9480i, 9480i CT SIP Administrator Guide EN - Manual (Page 380)

41-001343-01 Rev 03, Release 3.2.2 5-103
The following table identifies the configuration parameters for LLDP and ELIN and which method
you can use to configure each parameter. This table also indicates whether the parameters can be
configured by an Administrator, a User, or both.
Configuring LLDP-MED and ELIN
Use the following procedures to configure LLDP-MED and ELIN on the IP phones.
Use the following procedure to enable/disable LLDP-MED using the IP Phone UI.
Parameter Method of Configuration Who Can Configure
lldp Configuration Files Administrator
lldp interval Configuration Files Administrator
use lldp elin Configuration Files Administrator
lldp startinterval Configuration Files Administrator
LLDP Support IP Phone UI Administrator
LLDP Aastra Web UI Administrator
LLDP Packet Interval Aastra Web UI Administrator
LLDP ELIN Aastra Web UI Administrator and User
Configuration Files
For specific parameters you can set in the configuration files, see Appendix A, the section, “LLDP-MED and
ELIN Settings” on page A-138.
Note: You cannot configure the “LLDP Interval” or the “Use LLDP
ELIN” parameters via the IP Phone UI.
Aastra IP Phone UI
Step Action
1 Press Options, and then select Administrator Menu.
2 Select Network Settings.
3 Select Ethernet & VLAN.
4 Select LLDP Support.