Per-line settings – AASTRA 6700i series, 9143, 9480i, 9480i CT SIP Administrator Guide EN User Manual
Page 861
A-130
41-001343-01 Rev 03, Release 3.2.2
Per-Line Settings
Parameter –
sip lineN autodial number
Autodial Number
(in Web UI)
Aastra Web UI
Advanced Settings->LineN->Autodial Settings
Configuration Files aastra.cfg, <model>.cfg, <mac>.cfg
Description
On a per-line basis, this parameter specifies the SIP phone number that
the IP phone autodials when the handset is lifted from the phone cradle.
Valid values can be:
-1
(Default) The phone uses the global
autodial setting for this line.
Blank
(Empty field) Disables autodial on this line.
Valid SIP Number
Dials the SIP number specified for this line.
Format
Integer
Default Value
-1
Range
Any valid SIP number.
Examples
sip line1 autodial number: 8500
Parameter –
sip lineN autodial timeout
AutoDial Timeout
(in Web UI)
Aastra Web UI
Advanced Settings->LineN->Autodial Settings
Configuration Files aastra.cfg, <model>.cfg, <mac>.cfg
Description
On a per-line basis, this parameter specifies the time, in seconds, that
the phone waits to dial a preconfigured number after the handset is
lifted from the IP phone cradle.
If this parameter is set to 0 (hotline), the phone immediately dials a
preconfigured number when you lift the handset. If this parameter is set
to a value greater than 0, the phone waits the specified number of
seconds before dialing the preconfigured number (warmline) when you
lift the handset.
Default is 0 (hotline).
Format
Integer
Default Value
0
Range
0-120
Examples
sip line1 autodial timeout: 30