AASTRA 6700i series, 9143, 9480i, 9480i CT SIP Administrator Guide EN - Manual (Page 365)

5-88 41-001343-01 Rev 03, Release 3.2.2
Call Hold Reminder Timer & Frequency
There are two parameters an Administrator can set on the IP Phones along with the “call hold
reminder” and “call hold reminder during active calls” parameters:
• call hold reminder timer
• call hold reminder frequency
These parameters specify the time delay and time frequency of the ring splash that sounds when
you are on an active call and have placed another call on hold. You can configure these
parameters using the configuration files only.
Configuring “Call Hold Reminder Timer”
You use the following procedure to configure the “Call Hold Reminder Timer”.
Configuring “Call Hold Reminder Frequency”
You use the following procedure to configure the “Call Hold Reminder Frequency”.
Notes:
1. You must enable the “call hold reminder” and/or “call hold
reminder during active calls” parameter(s) for the above parameters to
work.
2. A value of “0” for the “call hold reminder timer” parameter disables
the call hold reminder feature.
3. A value of “0” for the “call hold reminder frequency” parameter
prevents additional rings.
Configuration Files
For the specific parameter you can set in the configuration files for setting the “Call Hold Reminder Timer”,
see Appendix A, the section,
“Call Hold Reminder Timer” on page A-155.
Configuration Files
For the specific parameter you can set in the configuration files for setting the “Call Hold Reminder
Frequency”, see Appendix A, the section,
“Call Hold Reminder Frequency” on page A-156.