AASTRA 6700i series, 9143, 9480i, 9480i CT SIP Administrator Guide EN - Manual (Page 443)

5-166 41-001343-01 Rev 03, Release 3.2.2
speeddial/Xfer Key Requirements and Functionality
The speeddial/Xfer key has the following capabilities:
• speeddial/Xfer and speeddial
When the phone is in the “Idle” state, pressing the speeddial/Xfer key causes the phone to
go offhook and dial the predefined extension.
• speeddial/Xfer and Blind Transfer
When the phone is connected to a call, pressing the speeddial/Xfer key blind transfers the
call to the predefined target.
If transferring a call fails, a message “Transfer Failed” displays, and you can reconnect the
call (get the call back) by pressing the line key again.
• speeddial/Xfer and Call Forward
When the phone is in the “Ringing” state, pressing the speeddial/Xfer key forwards the call
to the predefined extension.
Configuring the BLF/Xfer Key and the speeddial/Xfer Key Using the Configuration
Files
You use the following parameters in the configuration files to configure the
BLF/Xfer key and/or speeddial/Xfer key on the IP Phone.
Note: On the 6739i, you can configure a BLF./Xfer and speeddial/Xfer
softkeys using the IP Phone UI also. For more information, see the Aastra
Model 6739i IP Phone User Guide.
Softkey Parameters Programmable Key Parameters Expansion Module Parameters
softkeyN type
softkeyN label
softkeyN value
softkeyN line
softkeyN states prgkeyN type
prgkeyN value
prgkeyN line expmodN keyN type
expmodN keyN label
expmodN keyN value
expmodN keyN line
Top Softkey Parameters
topsoftkeyN type
topsoftkeyN label
topsoftkeyN value
topsoftkeyN line