AASTRA 6700i series, 9143, 9480i, 9480i CT SIP Administrator Guide EN - Manual (Page 56)

41-001343-01 Rev 03, Release 3.2.2 1-39
Firmware Installation Information
Description
The firmware setup and installation for the IP phone can be done using any of the following:
• Phone User Interface via the keypad (Phone UI)
• Aastra Web-based user interface (Aastra Web UI)
When the IP phone is initialized for the first time, DHCP is enabled by default. Depending on the
type of configuration server setup you may have, the IP phone may download a firmware version
automatically, or you may need to download it manually.
Installation Considerations
The following considerations must be made before connecting the IP phone to the network:
• If you are planning on using dynamic IP addresses, make sure a DHCP server is enabled and
running on your network.
• If you are not planning on using dynamic IP addresses, see Chapter 4, the section,
“Configuring Network Settings Manually” on page 4-23 for manually setting up an IP address.
To install the IP phone hardware and cabling, refer to the model-specific
SIP IP Phone Installation Guide
.