AASTRA 6700i series, 9143, 9480i, 9480i CT SIP Administrator Guide EN - Manual (Page 636)

41-001343-01 Rev 03, Release 3.2.2 6-9
Boot Sequence Recovery Mode
You can force the IP phone into recovery mode by pressing the 1 and # keys during boot up when
the logo displays. This feature is enabled by default on the IP phone.
You can disable this feature using the following parameter in the configuration files:
•
force web recovery mode disabled
Valid values for this parameter are 0 (false) and 1 (true). Default is 0 (false).
A boot counter increments after each faulty boot. When the counter reaches a predetermined value,
it forces Web recovery mode. The counter is reset to zero upon a successful boot.
The predetermined value is set using the following parameter in the configuration files:
•
max boot count
A zero (0) value disables this feature. The default value is 10.
You can configure the boot sequence recovery mode parameters using the configuration files only.
Configuring Boot Sequence Recovery Mode
Configuration Files
For the specific parameters you can set in the configuration files for boot sequence recovery mode, see
Appendix A, the section,
“Boot Sequence Recovery Mode Settings.” on page A-238.