Vlan – AASTRA 6700i series, 9143, 9480i, 9480i CT SIP Administrator Guide EN User Manual
Page 132
41-001343-01 Rev 03, Release 3.2.2
3-45
VLAN
You can enable or disable VLAN and set specific VLAN IDs and priorities under Network
Settings.
Parameter In
IP Phone UI
Parameter in
Aastra Web UI
Parameters in
Configuration Files
Description
Global Settings
VLAN Enable
VLAN Enable
tagging enabled
Enables or disables VLAN on the IP phones.
For more information, see Chapter 4,
.
Other Priority
Priority, Non-IP
Packet
priority non-ip
Specifies the priority value for non-IP packets.
For more information, see Chapter 4,
.
LAN Port Settings (Port 0)
Phone VLAN ID
VLAN ID
VLAN id
VLAN is a feature on the IP phone that allows for
multiple logical Ethernet interfaces to send
outgoing RTP packets over a single physical
Ethernet as described in IEEE Std 802.3. On the IP
phone, you configure a VLAN ID that associates
with the physical Ethernet Port 0.
For more information, see Chapter 4,
.
SIP Priority
RTP Priority
RTCP Priority
SIP Priority
RTP Priority
RTCP Priority
tos priority map
This parameter is based on the Type of Service
(ToS), Differentiated Services Code Point (DSCP)
setting for SIP (tos sip parameter), RTP (tos rtp
parameter) and RTCP (tos rtcp parameter). It is
the mapping between the DSCP value and the
VLAN priority value for SIP, RTP, and RTCP
packets.
You enter the tos priority map value as follows:
(DSCP_1,Priority_1)(DSCP_2,Priority_2).....(DSC
P_64,Priority_64)
where the DSCP value range is 0-63 and the
priority range is 0-7. Mappings not enclosed in
parentheses and separated with a comma, or with
values outside the ranges, are ignored.
For more information, see Chapter 4,
.