Enabling/disabling directed call pickup, Configuring blf/blf list for directed call pickup – AASTRA 6700i series, 9143, 9480i, 9480i CT SIP Administrator Guide EN User Manual
Page 407
5-130
41-001343-01 Rev 03, Release 3.2.2
Enabling/Disabling Directed Call Pickup
Use the following procedure to enable or disable the Directed Call Pickup feature on the IP
phone.
Configuring BLF/BLF List for Directed Call Pickup
Use the following procedure to configure BLF/BLF List for Directed Call Pickup in the
configuration files.
Configuration Files
To enable/disable Directed Call Pickup on the IP phone using the configuration files, see Appendix A, the
section,
“Directed Call Pickup (BLF or XML Call Interception) Settings”
Aastra Web UI
1
Click on Basic Settings->Preferences->Directed Call Pickup Settings.
2
Enable the "Directed Call Pickup" field by checking the check box.
(Disable this field by unchecking the box). Default is disabled.)
3
(optional) Enter a prefix in the "Directed Call Pickup Prefix" field. For example, *98.
This prefix is appended to the beginning of the Directed Call Pickup number when dialed from the
BLF or BLF/List softkey.
4
Enable the "Play a Ring Splash" field by checking the check box.
(Disable this field by unchecking the box). Default is disabled.)
The IP phone plays a short "ring splash" when there is an incoming call on the BLF monitored
extension. If the "Play a Ring Splash" parameter is enabled, and the host tone is idle, the tone plays
a "ring splash".
5
Click
to save your changes.
Note:
You must enable Directed Call Pickup before performing these
procedures. See
“Enabling/Disabling Directed Call Pickup”
on
Configuration Files
To set BLF or BLF\List in the configuration files for Directed Call Pickup, see Appendix A, the sections:
•
“Softkey/Programmable Key/Feature Key/Expansion Module Key Parameters”
on
•
on