AASTRA 6700i series, 9143, 9480i, 9480i CT SIP Administrator Guide EN - Manual (Page 596)

41-001343-01 Rev 03, Release 3.2.2 5-319
Action URI Disconnected
The phones have a parameter, “action uri disconnected” that allow a disconnect event to occur
when the phone transitions from any active state (outgoing, incoming, connected, or calling) to an
idle state. This parameter can use the variable “$$LINESTATE$$”.
If the Administrator enables this feature (by specifying a disconnect URI), when a call is
disconnected, the phone checks to see if the event has a Disconnect URI configured. If the
phones finds a configured URI with a $$LINESTATE$$ variable, it replaces the $$LINESTATE$$
variable with the appropriate line state of the current active line. After all of the variables are
bound, the phone executes a GET on the URI. The following table lists the applicable values for
the $$LINESTATE$$ variable.
The Action URI Disconnect feature allows an Administrator to determine the reason for the
disconnect if required.
Note: The $$LINESTATE$$ variable is optional and not required when
enabling the “action uri disconnected” parameter.
$$LINESTATE$$ Value Description Meaning in a Disconnected URI
IDLE Phone is idle. N/A
DIALING Phone is offhook and ready to dial. N/A
CALLING A SIP INVITE was sent but no response
was received. Error occurred during the call.
OUTGOING Remote party is ringing. Call was cancelled.
INCOMING Local phone is ringing. Call was missed or cancelled.
CONNECTED Parties are talking. Call was successful.
CLEARING Call was released but not acknowledged. N/A
Note: If you enable the Action URI Disconnect feature by specifying a
URI, the URI is called when any disconnect event occurs including an
intercom call or a conference setup.