Configuring ring tones and tone sets, Configuration files, Ip phone ui – AASTRA 6700i series, 9143, 9480i, 9480i CT SIP Administrator Guide EN User Manual
Page 396
41-001343-01 Rev 03, Release 3.2.2
5-119
Configuring Ring Tones and Tone Sets
Use the following procedures to configure ring tones and tone sets on the IP phones.
Configuration Files
For specific parameters you can set in the configuration files for ring tones, see Appendix A, the section,
“Ring Tone and Tone Set Global Settings”
on
IP Phone UI
Step Action
For global configuration only:
1
Press
on the phone to enter the Options List.
2
Select Preferences.
3
Select Tones.
4
Select Set Ring Tone.
5
Select the type of ring tone (Tone 1 through Tone 5, or Silent).
6
Press Done to save the change.
7
Select Tone Set.
8
Select the country for which you want to apply the tone set.
Valid values are Australia, Brazil, Europe, France, Germany, Italy, Italy2, Malaysia, Mexico,
Brazil, Russia, Slovakia, UK, and US. Default is US.
9
Press Done to save the change.
The ring tone and tone set you select is immediately applied to the IP phone.
For the 6739i:
1
Press
on the phone to enter the Options List.
2
Press the <Audio> button.
3
Press the <Ring Tone> button. The following values display:
•
Tone 1 (Default)
•
Tone 2
•
Tone 3
•
Tone 4
•
Tone 5
•
Silent
4
Press the value you want to set for the Ring Tone.
5
Press the <Tone Set> button.