Configuring call forwarding – AASTRA 6700i series, 9143, 9480i, 9480i CT SIP Administrator Guide EN User Manual
Page 506
41-001343-01 Rev 03, Release 3.2.2
5-229
You can enable/disable CFWD and set a CFWD key using the configuration files or the Aastra
Web UI. You can set CFWD mode (Account, Phone, Custom) using the configuration files,
Aastra Web UI or IP Phone UI.
Important Notes
• In the configuration files, the “call forward key mode” parameter in the section,
is in addition to the previous call forward
parameter (call forward disabled). You can still use the previous call forwarding parameter if
desired in the configuration files.
• In the IP Phone UI, you can access the Call Forwarding features at the path Options->Call
Forward
or by pressing a configured CFWD key.
•
If you make changes to the configuration for CFWD via the IP Phone UI, you must
refresh the Aastra Web UI screen to see the changes.
Configuring Call Forwarding
You use the following parameters to set CFWD on the IP Phone using the configuration files:
•
call forward key mode
•
softkeyN type, topsoftkeyN type, prgkeyN type, or expmodX keyN type
•
softkeyN states
(optional)
Use the following procedures to configure Call Forwarding on the IP phones.
Note:
On the 6739i, you can configure a Call Forward softkey using the
IP Phone UI also. For more information, see the Aastra Model 6739i IP
Phone User Guide.
Notes:
1.
If there is no CFWD key configured on the phone or it is
removed, you can still set the CFWD modes via the IP Phone UI at the
path Options->Call Forward.
2.
If there is only one account configured on the phone, then the
mode setting is ignored and the phone behaves as if the mode was set
to “Phone”.
3.
When configuring a CFWD mode (All, Busy, No Answer) for
an account, you must configure a CFWD number for that mode in
order for the mode to be enabled.
Configuration Files
For specific last call forwarding parameters you can set in the configuration files, see Appendix A, the
sections,
•
on
.
•
“Softkey/Programmable Key/Feature Key/Expansion Module Key Parameters”
on