AASTRA 6700i series, 9143, 9480i, 9480i CT SIP Administrator Guide EN User Manual
Page 371
5-94
41-001343-01 Rev 03, Release 3.2.2
Configurable Status Code on Ignoring Incoming Calls
When a user presses the “Ignore” key on the phones during an incoming call, the phone rejects
the incoming call with a status code of “486 Busy Here”. The IP phones allow an administrator
to configure this status code. You can configure the status code using the configuration files
only.
Use the following parameter to configure a status code when ignoring incoming calls:
•
sip ignore status code
Configuring Status Codes on Ignoring Incoming Calls
You can use the following procedure to set the status code sent in the response when a user
presses the “Ignore” key.
Note:
Valid status codes are based on RFC3261.
Configuration Files
For the specific parameter you can set in the configuration files, see Appendix A, the section,
on