Switch focus to ringing line, Configuring “switch focus to ringing line, Switch focus to ringing line -82 – AASTRA 6700i series, 9143, 9480i, 9480i CT SIP Administrator Guide EN User Manual
Page 359: Switch focus to ringing, Line
5-82
41-001343-01 Rev 03, Release 3.2.2
Switch Focus to Ringing Line
An Administrator or User can control the behavior of the phone when it receives an incoming
call when it is already in a connected call. By default, the phone switches focus to the ringing
line to enable the user to see who is calling them.
You can turn off this functionality so that the phone now stays focused on the connected call.
You can do this using the “switch focus to ringing line” parameter in the configuration files or
the Aastra Web UI.
Configuring “Switch Focus to Ringing Line”
You use the following procedures to enable or disable “Switch Focus to Ringing Line”.
Note:
If you configure the BLF/Xfer key(s) and/or speeddial/Xfer
key(s) on the phone, you can enable or disable the switching of the
user interface focus to ringing line while the phone is in the connected
state.
Configuration Files
For specific parameters you can set in the configuration files for enabling disabling “Switch Focus to Ringing
Line”, see Appendix A, the section,
“Switch Focus to Ringing Line”
on