AASTRA 6700i series, 9143, 9480i, 9480i CT SIP Administrator Guide EN - Manual (Page 217)

4-54 41-001343-01 Rev 03, Release 3.2.2
3 Enter your Administrator password.
Note: The IP Phones accept numeric passwords only.
4 Select Network Settings.
5 Select Type of Service DSCP.
6 Select Type of Service SIP.
or
Select Type of Service RTP.
or
Select Type of Service RTCP.
7 Enter a value for “Type of Service SIP”. Default is 26.
or
Enter a value for “Type of Service RTP”. Default is 46.
or
Enter a value for “Type of Service RTCP”. Default is 46.
Valid values are 0 to 63.
Note: If you change the ToS/DSCP setting for a Protocol, and VLAN is enabled, you will need to map
the applicable priority to the Protocol setting as shown in the table
“DSCP Range/VLAN Priority” on
page 4-53 For more information, see the section “Configuring VLAN (optional)” on page 4-55 .
8 Press Done (3 times) to save the changes.
Note: The session prompts you to restart the IP phone to apply the configuration settings
9 Select Restart.
For the 6739i:
1
Press the Options key on the phone to enter the Options List.
2 Press Advanced. A keyboard displays.
3 Enter the Administrator password using the keyboard. Default is “22222”.
4 Press Network.
5 Press to scroll to the next screen.
6 Press Type of Service DSCP.
7 Press Type of Service SIP, and then enter a value for ToS. Default is 26.
8 Press Type of Service RTP, and then enter a value for ToS. Default is 46.
9 Press Type of Service RTCP, and then enter a value for ToS. Default is 46.
10 Press until the Options List screen displays.
11 Press Restart to restart the phone for the change to take affect.
IP Phone UI
Step Action