Configuring autodial using the aastra web ui – AASTRA 6700i series, 9143, 9480i, 9480i CT SIP Administrator Guide EN User Manual
Page 265
![background image](/manuals/253368/265/background.png)
4-102
41-001343-01 Rev 03, Release 3.2.2
Configuring Autodial Using the Aastra Web UI
Use the following procedure to configure Autodial using the Aastra Web UI.
By default, your IP phone uses the global settings you specify for Autodial for all lines on your
IP phone. However, you can also configure Autodial on a per-line basis.
Aastra Web UI
Global Configuration
1
Click on Advanced Settings->Global SIP->Autodial Settings.
2
In the “Autodial Number” field, specify the SIP number that the IP phone dials whenever the IP
phone is off-hook. An empty (blank) value disables autodial on the phone.
For example: 8500
3
In the “Autodial Timeout” field, specify a value, in seconds, for the timer as follows:
•
If you want the IP phone to autodial the number immediately (hotline) whenever the IP phone is
off-hook, accept the default value of 0.
•
If you want to specify a length of time for the IP phone to wait before dialing the number, enter
the length of time (in seconds). For example: 30
Valid values are 0 to 120.
4
Click
to save your changes.