AASTRA 6700i series, 9143, 9480i, 9480i CT SIP Administrator Guide EN - Manual (Page 427)

5-150 41-001343-01 Rev 03, Release 3.2.2
Feature Key Programming Guidelines
The following are guidelines to use when programming the feature keys on the handset:
• All handsets paired with the same Base Station have the same programmed functions since
the web interface applies the functions to all the handsets paired with that base.
• A newly registered handset or handset that was out-of-range during the programming needs
to perform an "off-hook and on-hook" sequence in order for the newly programmed function
to be broadcasted to the affected handsets. Simply press the v key from the idle state to
go off-hook. Then, press the y key to go back on-hook.
• Duplicate functions can exist in the feature key as there is no filtering or duplicate checking
done on the handset or the base.
• If no line keys are programmed for the feature key, the handset is restricted to intercom calls
only.
• If all 12 programmable functions have been programmed to "None", the user is presented
with a List empty message when the feature key is pressed.
• For security reasons, the user has 180 seconds (3 minutes) to complete the programming.
Otherwise, the phone displays the following error:
** Error **: Session expired, Please reload page.
• For security reasons, the user must submit the page from the same browser that was used to
load the page. If the user tries to submit the page from any other IP address, the following
error displays:
** Error ** Session invalid. Different Client IP Addresses. — Please reload page
Handset Feature Key Functions
You can configure the features keys on the 6757i CT handset to perform specific functions using
the configuration files or the Aastra Web UI.The following table identifies the available
functions for the feature keys on the 6757i CT handset.
List empty
Use web page to
configure