AASTRA 6700i series, 9143, 9480i, 9480i CT SIP Administrator Guide EN - Manual (Page 774)

41-001343-01 Rev 03, Release 3.2.2 A-43
PC Port (Ethernet Port 1) Parameters
Parameter –
vlan id port 1
VLAN ID
(for PC Port in
Web UI)
IP phone UI Options->Administrator Menu->
Network Settings->VLAN->
Passthrough->VLAN ID
Aastra Web UI Advanced Settings->Network->VLAN->Port 1
Configuration Files aastra.cfg, <model>.cfg, <mac>.cfg
Description Specifies the VLAN ID used to pass packets through to a PC via Port 1.
Note: If you set the VLAN id port 1 (passthrough port) to 4095, all
untagged packets are sent to this port. The following is an example of
configuring the phone on a VLAN where all untagged packets are sent to
the passthrough port.
Example
You enable tagging on the phone port as normal but set the
passthrough port (VLAN id port 1) to 4095. The following example
sets the phone to be on VLAN 3 but the passthrough port is
configured as untagged.
tagging enabled: 1
Vlan id: 3
Vlan id port 1: 4095
Note: PC Port parameters are not applicable to the 6730i IP Phone.
Format Integer
Default Value 1
Range 1 to 4095
Example Vlan id port 1: 3
Parameter –
QoS eth port 1 priority
Priority
(for PC Port in
Web UI)
IP phone UI Options->Administrator Menu->
Network Settings->VLAN->Passthrough
->Priority
Aastra Web UI Advanced Settings->Network->VLAN->Port 1
Configuration Files aastra.cfg, <model>.cfg, <mac>.cfg
Description Specifies the priority value used for passing VLAN packets through to a
PC via Port 1.
Format Integer
Default Value 0
Range 0 to 7
Example QoS eth port 1 priority: 3