AASTRA 6700i series, 9143, 9480i, 9480i CT SIP Administrator Guide EN - Manual (Page 218)

41-001343-01 Rev 03, Release 3.2.2 4-55
.
Configuring VLAN (optional)
Use the following procedures to configure VLAN on the IP phone.
Aastra Web UI
Step Action
1 Click on Advanced Settings->Network->Type of Service,DSCP .
2 Select a Protocol field:
•
“SIP”
or
•
“RTP”
or
•
“RTCP”
3 Enter a value from 0 to 63. Default values are as follows:
SIP = 26
RTP = 46
RTCP = 46
Note: If you change the ToS/DSCP setting for a Protocol, and VLAN is enabled, you will need to map
the applicable priority to the Protocol setting as shown in the table
“DSCP Range/VLAN Priority” on
page 4-55 For more information, see the section “Configuring VLAN (optional)” on page 4-55 .
4 Click to save your settings.
Notes:
1. VLAN is disabled by default. When you enable VLAN, the IP
phones use the default settings for each VLAN parameter. You can
change the default settings if required using the following procedure.
2. PC Port parameters are not applicable to the 6730i IP Phone.