AASTRA 6700i series, 9143, 9480i, 9480i CT SIP Administrator Guide EN User Manual
Page 342
41-001343-01 Rev 03, Release 3.2.2
5-65
Configuring the SIP Local Dial Plan, Dial Plan Terminator, and Digit Timeout
Use the following procedures to configure the SIP Local Dial Plan using the configuration files or
the Aastra Web UI.
Configuration Files
For specific parameters you can set in the configuration files, see Appendix A, the section,
Aastra Web UI
1
Click on Basic Settings->Preferences.
2
In the "Local Dial Plan" field, enter a valid local dial plan (up to 512 alphanumeric characters) for the
IP phone. Default is X+#|XX+*. Enter prepended digits or a “;”to present a secondary dial tone if
required.
Note: If a User enters a dial plan longer than 512 characters, or a parsing error occurs, the phone
uses the default dial plan of “x+#|xx+*”.
3
Enable the "Send Dial Plan Terminator" field by checking the check box. (Disable this field by
unchecking the box). Default is disabled.
4
In the "Digit Timeout (in seconds)" field, enter a timeout value. This is the length of time, in
seconds, he phone waits before dialing. Default is 4 seconds.
5
Click
to save your changes.