AASTRA 6700i series, 9143, 9480i, 9480i CT SIP Administrator Guide EN User Manual
Page 432
41-001343-01 Rev 03, Release 3.2.2
5-155
You can use the following configuration file parameters to control which key types to display and
specify in which order to display them in:
•
softkey selection list
•
feature key selection list
If no value is specified for the “softkey selection list” and/or “feature key selection list”
parameters, the key “Type” list displays all of the key types by default.
If an Administrator configures specific key types for a phone in the configuration file, and the
phone for which he downloads the configuration to already has key types configured on it, those
key types display in the key list for those keys, in addition to the key types specified by the
Administrator. For example, a phone has a Park key and a Pickup key already configured on the
phone, and the Administrator downloads a configuration file to the phone that has specific key
types of None, Line, speeddial, and XML. After the configuration file is downloaded, the Park key
list will show None, Line, speeddial, XML, and Park; the Pickup key list will show None, Line,
speeddial, XML, and Pickup; all other keys that were configured as None before the download will
show only None, Line, speeddial, and XML.
Customizing the Key Type List Using the Configuration Files
Use the following procedure to configure the Key Type List that displays in the Aastra Web UI.
Notes:
1.
Any key types configured that do not apply to the phone are
ignored.
2.
The SAVE and DELETE keys appear by default as Keys 1 and 2 on
the 6753i and 9143i, and as Keys 5 and 6 on the 6730i and 6731i, unless
your Administrator configured these keys as other functions.
3.
An Administrator must use the English value when configuring the
key types in the configuration files.
5.
After configuring specific key types for a phone, the key types in
the Aastra Web UI display the same for both the User and Administrator
Web interfaces for that phone.
Configuration Files
For specific parameters you can set in the configuration files, see Appendix A, the section,