AASTRA 6700i series, 9143, 9480i, 9480i CT SIP Administrator Guide EN - Manual (Page 372)

41-001343-01 Rev 03, Release 3.2.2 5-95
Message Waiting Indicator Line
A User or Administrator can configure the Message Waiting Indicator (MWI) to illuminate for a
specific line or for all lines. For example, if you configure the MWI LED on line 3 only, the LED
illuminates if a voice mail is pending on line 3. If you configure the MWI LED for all lines, the
LED illuminates if a voice mail is pending on any line on the phone (lines 1 through 9).
A User can configure the MWI using the Aastra Web UI only. An Administrator can configure the
MWI on single or all lines using the configuration files or the Aastra Web UI.
Configuring Message Waiting Indicator (MWI)
Use the following procedures to configure MWI on the IP phone.
Configuration Files
For specific parameters you can set in the configuration files, see Appendix A, the section, “Message
Waiting Indicator Settings” on page A-159.
Aastra Web UI
1 Click on Basic Settings-> Preferences->General.
2 In the “Message Waiting Indicator Line” field, select a single line from 1 to 9, or select “All” for all
lines. If you select a single line, the MWI illuminates when a voice mail message is pending on that
line. If you select all lines, the MWI illuminates when a voice mail message is pending on any line
from 1 to 9.
3 Click to save your changes.