Call waiting tone, Configuring call waiting tone – AASTRA 6700i series, 9143, 9480i, 9480i CT SIP Administrator Guide EN User Manual
Page 350
41-001343-01 Rev 03, Release 3.2.2
5-73
Call Waiting Tone
You can also enable or disable the playing of a short “call waiting tone" when there is an incoming
call on your phone using the “Play Call Waiting Tone” parameter. This feature is enabled by
default. If you have Call Waiting enabled, and a call comes into the line for which you are on an
active call, a tone is audible to notify you of that incoming call.
A User or Administrator can configure this feature using the Aastra Web UI. An Administrator can
also configure this feature using the configuration files.
Configuring Call Waiting Tone
Use the following procedures to configure the Call Waiting Tone feature on the IP phone.
Note:
The Call Waiting Tone feature works only if Call Waiting is
enabled.
Configuration Files
For specific parameters you can set in the configuration files, see Appendix A, the section,
on