AASTRA 6700i series, 9143, 9480i, 9480i CT SIP Administrator Guide EN - Manual (Page 500)

41-001343-01 Rev 03, Release 3.2.2 5-223
Using the Park Call/Pickup Parked Call Feature
Use the following procedures on the IP phones to park a call and pick up a parked call.
7 In the "Type" field, select Pickup.
Note: The” Value” and “Line” fields are already configured from the “Park Pickup Config” field.
8 Click to save your changes.
9 Click on Operation->Reset.
10 Click on Reset, then click to restart the IP phone and apply the changes.
IP Phone UI
Step Action
Parking a Call
1
While on a live call, press the "Park" softkey.
2 Perform the following for your specific server:
If the call is parked successfully, the response is either a greeting voice confirming that the call was
parked, or a hang up occurs. The parked call party will get music on hold.
3 If the call fails, you can pick up the call (using the next procedure) and press the "Park" softkey again
to retry step 2.
Picking up a Parked Call
4
Pick up the handset on the phone.
5 Enter the extension number where the call was parked.
6 Press the "Pickup" softkey.
If the call pick up is successful, you are connected with the parked call.
Aastra Web UI
For Asterisk Server:
- Server announces the
extension number where the call
has been parked. Once the call is
parked, press the Goodbye key
to complete parking.
For BroadWorks Server:
- After you hear the greeting from
the CallPark server, enter the
extension where you want to
park the call.
For Sylantro Server:
- Enter the extension number
where you want to park the call,
followed by "#" key.