AASTRA 6700i series, 9143, 9480i, 9480i CT SIP Administrator Guide EN - Manual (Page 391)

5-114 41-001343-01 Rev 03, Release 3.2.2
speeddialKey Mapping
There are hard keys on your phone, such as Hold, Redial, Xfer, and Conf that are configured by
default for specific call-handling features. (See the product-specific User Guide for more
information about these key functions.
Enabling/Disabling Redial, Xfer, and Conf Keys
You can enable or disable the Redial, Xfer, and Conf keys as required using the following
parameters in the configuration files:
•
redial disabled
• conference disabled
• call transfer disabled
Valid values for this parameter are 0 (enabled) and 1 (disabled).
If this parameter is set to 1, the key is not active and is ignored if pressed by the user. For "redial
disabled " the value of 1 does not save the dialed number to the "Redial List".
If this parameter is set to 0, the key is active and can be pressed by the user.
This feature is configurable via the configuration files only.
Use the following procedure to enable/disable the Redial, Xfer, and Conf keys.
Notes:
1. On 8 and 11-Line LCD phones, the Xfer and Conf
keys are hard-coded by default on keys 5 and 6 to the left of the
LCD display and cannot be reassigned. The Xfer and Conf labels
display when you lift the handset. To disable these keys, see
“Enabling/Disabling Redial, Xfer, and Conf Keys” on page 5-114 .
2. On the 3-Line LCD phones, the Xfer and Conf keys are
assigned by default to available keys, respectively. These keys are
programmable keys and can be reassigned if applicable. To disable
these keys, see “Enabling/Disabling Redial, Xfer, and Conf Keys”
on page 5-114 .
Configuration Files
For specific parameters you can set in the configuration files, see Appendix A, the section, “Mapping Key
Settings” on page A-195.