AASTRA 6700i series, 9143, 9480i, 9480i CT SIP Administrator Guide EN User Manual
Page 415
5-138
41-001343-01 Rev 03, Release 3.2.2
You can enable or disable the softkey states using the configuration files or the Aastra Web UI.
In the Aastra Web UI, you disable a state by unchecking the box for that operational state.
In the configuration files, you use the following parameters to enable and disable operational
states:
•
softkeyN states
You can enter multiple values (idle, connected, incoming, outgoing, busy) for the "softkeyN
state" parameter. For example:
softkeyN states: idle connected
You must associate the softkeyN state parameter with a specific softkey. In the following
example, the softkeyN states parameter is associated with softkey 12:
softkey12 type: speeddial
softkey12 label: voicemail
softkey12 value *89
softkey12 states: outgoing
Note:
The IP phone idle screen condenses the softkeys. So in the
previous example, softkey 12 will appear in position 1 if no other
softkeys are set. A softkey type of "empty" does not display on the idle
screen at all. For more information about the softkey type of "empty" see
Appendix A, the section,
“Softkey Settings for 8 and 11-Line LCD
on
.