Rockwell Automation 284E ArmorStart with EtherNet/IP - User Manual - Manual (Page 105)

Rockwell Automation Publication 280E-UM001B-EN-P - July 2012 105
Chapter
6
Optional HOA Keypad Operation
Introduction This chapter provides a basic understanding of the programming of the factory-
installed optional built-in Hand/Off/Auto (HOA) keypad. The HOA keypad
can be programmed for maintained or momentary operation.
Figure 64 - Optional HOA Keypads
Keypad Description The keys found on the optional HOA keypads are described below:
Available on Bulletin 281E Available on Bulletin 284E Available on Bulletin 280E
Table 17 - HOA Keypad – Key Description
HAND The Hand key will initiate starter operation
AUTO
The Auto key allows for Start/Stop control via the communications
network
OFF If the starter is running, pressing the OFF key will cause the starter to stop.
REV The REV key selects reverse direction of the motor
FWD The FWD key selects forward direction of the motor
DIR Arrow The Dir arrow selects the direction of the motor, either forward or reverse.
JOG
When pressed, JOG will be initiated if no other control devices are sending
a stop command. Releasing the key will cause the drive to stop, using
selected stop mode.