Chapter 7, Bulletin 280e/281e/284e programmable parameters, Basic setup parameters – Rockwell Automation 284E ArmorStart with EtherNet/IP - User Manual User Manual
Page 111: Parameter groups, Basic setup parameters parameter groups, Chapter
Rockwell Automation Publication 280E-UM001B-EN-P - July 2012
111
Chapter
7
Bulletin 280E/281E/284E
Programmable Parameters
Basic Setup Parameters
To configure the basic ArmorStart functionality refer to Table 18 below. These
are the minimum setup configurations required for Bulletin 280E/281E or
Bulletin 284E. There are additional capabilities and motor protection that are
not enabled or left at their default values.
Parameter Groups
Table 18 - Quick Parameter Setup
Bulletin 280E/281E
Bulletin 284E
106 FLA Setting
107 Overload Class
108 OL Reset Level
131 Motor NP Volts
132 Motor NP Hertz
133 Motor OL Current
134 Minimum Freq
135 Maximum Freq
137 Stop Mode
138 Speed Reference
139 Accel Time 1
140 Decel Time 1
Common to Bulletin 280E/281E and Bulletin 284E Units
Bulletin 284E
Units Only
Basic Status
Produced Assembly
Config Group
Starter Protection
User I/O Config
Miscellaneous Config
Drive I/O Config
1 Hdw Inputs
2 DeviceIn Data
3 DeviceOut Data
4 Trip Status
5 Starter Status
6 InternalLinkStat
7 Starter Command
22 Breaker Type
56 Base Enclosure
57 Base Options
58 Wiring Options
59 Starter Enclosure
60 Starter Options
61 Last Pr Fault
62 Warning Status
63 Base Trip
13 Int00DeviceOut Cfg
14 Int01DeviceOut Cfg
15 Int02DeviceOut Cfg
16 Int03DeviceOut Cfg
23 Pr FltResetMode
24 Pr Fault Enable
25 Pr Fault Reset
26 Str Net FltState
27 Str Net FltValue
28 Str Net IdlState
29 Str Net IdlValue
30 Anti-bounce On Delay
31 Anti-bounce OFF Delay
32 In Sink/Source
33 OutA Pr FltState
34 OutA Pr FltValue
35 OutA Net FltState
36 OutA Net FltValue
37 OutA Net IdlState
38 OutA Net IdlValue
39 OutB Pr FltState
40 OutB Pr FltValue
41 OutB Net FltState
42 OutB Net FltValue
43 OutB Net IdlState
44 OutB Net IdlValue
8 Network Override
9 Comm Override
45 Keypad Mode
46 Keypad Disable
47 Set To Defaults
48 Drive Control
49 DrvIn Pr FltState
50 DrvIn Pr FltValue
51 DrvIn Net FltState
52 DrvIn Net FltValue
53 DrvIn Net IdlState
54 DrvIn Net IdlValue
55 High Speed Enable