Rockwell Automation 284E ArmorStart with EtherNet/IP - User Manual - Manual (Page 315)

Rockwell Automation Publication 280E-UM001B-EN-P – July 2012 315
Using DeviceLogix Appendix C
Figure 100 - Bulletin 284E Produced Network Bits in DeviceLogix Output
Table 52 -
Refer to table 22 - Parameters 170…177 Preset Freq Options for predefined
accel and decel
Accel2 Accel1 Description
0 0 No Command
0 1 Accel 1 Enable
1 0 Accel 2 Enable
1 1 Hold Accel Rate Selected
Decel 2 Decel 1
0 0 No Command
0 1 Decel 1 Enable
1 0 Decel 2 Enable
1 1 Hold Decel Rate Selected
Freq Ctrl 2 Freq Ctrl 1 Freq Ctrl 0
0 0 0 No Command
0 0 1 Freq Source = P136 (Start Source)
0 1 0 Freq Source = P169 (Internal Freq)
0 1 1 Freq Source = Comms
1 0 0 P170 (Preset Freq 0) (Accel/Decel 1)
1 0 1 P171 (Preset Freq 1) (Accel/Decel 1)
1 1 0 P172 (Preset Freq 2) (Accel/Decel 2)
1 1 1 P173 (Preset Freq 3) (Accel/Decel 2)