Rockwell Automation 284E ArmorStart with EtherNet/IP - User Manual - Manual (Page 312)

312 Rockwell Automation Publication 280E-UM001B-EN-P – July 2012
Appendix C Using DeviceLogix
11. From the toolbar, Click on the “Bit Output” button and select “Run
Forward”
from the hardware boolean tree. Run Forward is the relay
controlling the coil of the contactor.
12. Move the cursor into the grid and place the Output to the right of the reset
function block.
13. Connect the output of the reset function block to Run Forward.
14. Click on the “Verify” button located in the toolbar or select “Logic Verify”
from the “Tools” pull-down menu.