Rockwell Automation 284E ArmorStart with EtherNet/IP - User Manual - Manual (Page 181)

Rockwell Automation Publication 280E-UM001B-EN-P – July 2012 181
Bulletin 280E/281E/284E Programmable Parameters Chapter 7
Bus Reg Mode
Enables the bus regulator.
0 = Disable
1 = Enabled
Parameter Number 217
Related Parameters —
Access Rule GET/SET
Data Type UINT
Group Drive Advanced Setup
Units —
Minimum Value 0
Maximum Value 1
Default Value 1
Current Limit 2
Maximum output current allowed
before current limiting occurs. This
parameter is only active if Parameters
151…154 (Digital In x Sel) is set to
Option 25 (Current Lmt2) and is
active.
Parameter Number 218
Related Parameters 133, 151…154, 189
Access Rule GET/SET
Data Type UINT
Group Drive Advanced Setup
Units 0.1 A
Minimum Value 0.0 A
Maximum Value Drive rated amps x 1.8
Default Value Drive rated amps x 1.5
Skip Frequency
Sets the frequency at which the drive
will not operate.
Parameter Number 219
Related Parameters 220
Access Rule GET/SET
Data Type UINT
Group Drive Advanced Setup
Units 0.1 Hz
Minimum Value 0.0
Maximum Value 400.0 Hz
Default Value 0.0 Hz
Skip Freq Band
Determines the band width around
Parameter 219 (Skip Frequency).
Parameter 220 (Skip Freq Band) is
split applying 1/2 above and 1/2
below the actual skip frequency. A
setting of 0.0 disables this parameter.
Parameter Number 220
Related Parameters 219
Access Rule GET/SET
Data Type UINT
Group Drive Advanced Setup
Units 0.1 Hz
Minimum Value 0.0 Hz
Maximum Value 30.0 Hz
Default Value 0.0 Hz