Rockwell Automation 284E ArmorStart with EtherNet/IP - User Manual - Manual (Page 194)

194 Rockwell Automation Publication 280E-UM001B-EN-P – July 2012
Chapter 7 Bulletin 280E/281E/284E Programmable Parameters
26 Str Net FltState
This parameter in conjunction with Parameter 27 (Str
Net FltValue) defines how the starter will respond
when a fault occurs as determined by Parameter 27.
0 =
Goto Fault Value
Starter Protection Common
27 Str Net FltValue
This parameter determines how the starter will be
commanded in the event of a fault.
0 = OFF Starter Protection Common
28 Str Net IdlState
This parameter determines response when Idle fault
occurs. 0 =
Goto Fault Value
Starter Protection Common
29 Str Net IdlValue
This parameter determines the state that starter
assumes when the network is idle and Parameter 28
(Str Net IdlState) is set to “Goto Fault Value”.
0 = OFF Starter Protection Common
30 Off-to-On Delay
This parameter allows the installer to program a time
duration before being reported ON.
0 User I/O Configuration Common
31 On-to-Off Delay
This parameter allows the installer to program a time
duration before being reported OFF.
0 User I/O Configuration Common
32 In Sink/Source
This parameter allows the installer to program the
inputs to be sink or source.
0 = Sink User I/O Configuration Common
33 OutA Pr FltState
This parameter in conjunction with Parameter 34 (OutA
Pr FltValue) defines how Output A will respond when a
trip occurs.
0 =
Goto PrFlt Value
User I/O Configuration Common
34 OutA Pr FltValue This parameter determines the state the Output A. 0 = Open User I/O Configuration Common
35 OutA Net FltState
This parameter in conjunction with Parameter 36 (OutA
Net FltValue) defines how Output A will respond. 0 =
Goto Fault Value
User I/O Configuration Common
36 OutA Net FltValue This parameter determines the state that Output. 0 = Open User I/O Configuration Common
37 OutA Net IdlState
This parameter in conjunction with Parameter 38 (OutA
Net IdlValue) defines how Output A will respond when
the network is idle.
0 =
Goto Idle Value
User I/O Configuration Common
38 OutA Net IdlValue
This parameter determines the state that Output A
assumes when the network is idle and Parameter 37
(OutA Net IdlState) is set to “0”.
0 = Open User I/O Configuration Common
39 OutB Pr FltState
This parameter in conjunction with Parameter 40 (OutB
Pr FltValue) defines how Output B will respond when a
protection trip occurs.
0 =
Goto PrFlt Value
User I/O Configuration Common
40 OutB Pr FltValue
This parameter determines the state the Out B assumes
when a protection trip occurs and Parameter 39 (OutB
Pr FltState) is set to “0”.
0 = Open User I/O Configuration Common
41 OutB Net FltState
This parameter in conjunction with Parameter 42 (OutB
Net FltValue) defines how Output B will respond when
a network fault occurs.
0 =
Goto Idle Value
User I/O Configuration Common
42 OutB Net FltValue
This parameter determines the state that Output B
assumes when a network fault occurs and Parameter
41 (OutB Net FltState) is set to “0”.
0 = Open User I/O Configuration Common
43 OutB Net IdlState
This parameter in conjunction with Parameter 44 (OutB
Net IdlValue) defines how Output B will respond when
the network is idle.
0 =
Goto PrFlt Value
User I/O Configuration Common
Table 28 - ArmorStart Common Parameters
Parameter
Number Parameter Name Description Factory Default Group Controller