Rockwell Automation 284E ArmorStart with EtherNet/IP - User Manual - Manual (Page 283)

Rockwell Automation Publication 280E-UM001B-EN-P – July 2012 283
CIP Information Appendix B
Instance 150
This is the default input (produced) assembly for Bulletin 280E/281E starters.
Note: Byte 0 - 3 refers to PLC communication status. All 1s (bit high) indicates a
connection fault (communication fault) exists or all 0s (bit low) connection
is normal.
Instance 151
This is the default input (produced) assembly for Inverter Type Distributed
Starters.
Instance 150 "Starter Stat" - Default Status Assembly for Bulletin 280E/281E Starters
Byte Bit 7 Bit 6 Bit 5 Bit 4 Bit 3 Bit 2 Bit 1 Bit 0
0 Reserved (AOP Tag name: {name}:I.Fault)
1 Reserved (AOP Tag name: {name}:I.Fault)
2 Reserved (AOP Tag name: {name}:I.Fault)
3 Reserved (AOP Tag name: {name}:I.Fault)
4 — — — Ready RunningReverse RunningForward WarningPresent TripPresent
5 — — DisconnectClosed Hand In3 In2 In1 In0
6 Pt07DeviceOut Pt06DeviceOut Pt05DeviceOut Pt04DeviceOut Pt03DeviceOut Pt02DeviceOut Pt01DeviceOut Pt00DeviceOut
7 Logic Enable Pt14DeviceOut Pt13DeviceOut Pt12DeviceOut Pt11DeviceOut Pt10DeviceOut Pt09DeviceOut Pt08DeviceOut
8 Value of the parameter pointed to by “Parameter Int00DeviceOut Cfg” (low byte) - ProducedWord0Param
9 Value of the parameter pointed to by “Parameter Int00DeviceOut Cfg” (high byte) - ProducedWord0Param
10 Value of the parameter pointed to by “Parameter Int01DeviceOut Cfg” (low byte) - ProducedWord1Param
11 Value of the parameter pointed to by “Parameter Int01DeviceOut Cfg” (high byte) - ProducedWord1Param
12 Value of the parameter pointed to by “Parameter Int02DeviceOut Cfg” (low byte) - ProducedWord2Param
13 Value of the parameter pointed to by “Parameter Int02DeviceOut Cfg” (high byte) - ProducedWord2Param
14 Value of the parameter pointed to by “Parameter Int03DeviceOut Cfg” (low byte) - ProducedWord3Param
15 Value of the parameter pointed to by “Parameter Int03DeviceOut Cfg” (high byte) - ProducedWord3Param
Produce Assembly - Instance 151 “Drive Status” - 284E Starters
Byte Bit 7 Bit 6 Bit 5 Bit 4 Bit 3 Bit 2 Bit 1 Bit 0
0 Reserved - {name}:I.Fault
1 Reserved - {name}:I.Fault
2 Reserved - {name}:I.Fault
3 Reserved - {name}:I.Fault
4 AtReference Network
ReferenceStatus
NetControlStatus Ready RunningReverse RunningForward WarningPresent TripPresent
5 OutputContactor
Status
BrakeContactor
Status
DisconnectClosed Hand In3 In2 In1 In0
6 OutputFrequency (Low) (xxx.x Hz)