Rockwell Automation 284E ArmorStart with EtherNet/IP - User Manual - Manual (Page 160)

160 Rockwell Automation Publication 280E-UM001B-EN-P – July 2012
Chapter 7 Bulletin 280E/281E/284E Programmable Parameters
Drive Setup Group (Bulletin 284E only)
Timer Status
The current value of the timer when
timer is enabled.
Parameter Number 126
Access Rule GET
Data Type UINT
Group Drive Display
Units 0.1 sec
Minimum Value 0
Maximum Value 9999
Default Value Read Only
StpLogic Status
When Parameter 138 (Speed
Reference) is set to "6" (StpLogic), this
parameter will display the current
step of StepLogic as defined by
Parameters 240…247 (StpLogic X).
Parameter Number 128
Access Rule GET
Data Type UINT
Group Drive Display
Units 1
Minimum Value 0
Maximum Value 8
Default Value Read Only
Torque Current
The current value of the motor torque
current.
Parameter Number 129
Access Rule GET
Data Type UINT
Group Drive Display
Units 0.01
Minimum Value 0.00
Maximum Value Drive Rated Amps x 2
Default Value Read Only
Motor NP Volts
Set to the motor nameplate rated
volts.
Parameter Number 131
Related Parameters 104, 184, 185…187
Access Rule GET/SET
Data Type UINT
Group Drive Setup
Units 1V AC
Minimum Value 20
Maximum Value 480V
Default Value Based on Drive Rating
O
Stop drive before changing this
parameter.