Rockwell Automation 284E ArmorStart with EtherNet/IP - User Manual - Manual (Page 323)

Rockwell Automation Publication 280E-UM001B-EN-P – July 2012 323
Using DeviceLogix Appendix C
Bulletin 284 ArmorStart Status Bits
The following table contains the status bit definitions for ArmorStart 284
Bulletin 284 ArmorStart Fault Bits
The screen capture below shows how to choose Fault Bits in the ladder editor.
Status bit declaration
0
= Tripped
1 = Warning
2 = Running Fwd
3 = Running Rev
4 = Ready
5 = Net Ctl Status
6 = Net Ref Status
7 = At Reference
8 = Drive Opto 1
9 = Drive Opto 2
10 = Keypad Jog
11= Keypad Hand
12 = HOA Status
13 = 140M On
14 = Contactor 1
15 = Contactor 2
16 = Explicit Msg Cnxn Exists
17 = IO Cnxn Exists
18 = Explicit Cnxn Fault
19 = IO Cnxn Fau
20 = IO Cnxn Idle
21 = Keypad Hand Direction