Rockwell Automation 284E ArmorStart with EtherNet/IP - User Manual - Manual (Page 143)

Rockwell Automation Publication 280E-UM001B-EN-P – July 2012 143
Bulletin 280E/281E/284E Programmable Parameters Chapter 7
Produced Assembly Config Group
Base Trip
The parameter provides the Base
Module Trip Status.
Parameter Number 63
Access Rule GET
Data Type WORD
Group Basic Status
Units —
Minimum Value 0
Maximum Value 65535
Default Value 0
Bit
Warning
15 14 13 12 11 10 9 8 7 6 5 4 3 2 1 0
— — — — — — — — — — — — — — — X EEPROM Fault
— — — — — — — — — — — — — — X — Internal Comm
— — — — — — — — — — — — — X — — Hardware Fault
— — — — — — — — — — — — X — — — Control Module
X X X X X X X X X X X X — — — — Reserved
Int00DeviceOut Cfg
This parameter is used to specify
Int00DeviceOut of produced assembly
150 or 151.
Parameter Number 13
Access Rule GET/SET
Data Type USINT
Group Produced Assembly Config
Units —
Minimum Value 0
Maximum Value 263
Default Value 1
Int01DeviceOut Cfg
This parameter is used to specify
Int01DeviceOut of produced assembly
150 or 151.
Parameter Number 14
Access Rule GET/SET
Data Type USINT
Group Produced Assembly Config
Units —
Minimum Value 0
Maximum Value 263
Default Value 4