Rockwell Automation 284E ArmorStart with EtherNet/IP - User Manual - Manual (Page 184)

184 Rockwell Automation Publication 280E-UM001B-EN-P – July 2012
Chapter 7 Bulletin 280E/281E/284E Programmable Parameters
IR Voltage Drop
Value of volts dropped across the
resistance of the motor stator.
Parameter Number 228
Related Parameters 227
Access Rule GET/SET
Data Type UINT
Group Drive Advanced Setup
Units 0.1V AC
Minimum Value 0.0
Maximum Value 230
Default Value Based on Drive Rating
Flux Current Ref
Value of amps for full motor flux.
Parameter Number 229
Related Parameter 227
Access Rule GET/SET
Data Type UINT
Group Drive Advanced Setup
Units 0.01 A
Minimum Value 0.00
Maximum Value Motor NP Volts
Default Value Based on Drive Rating
PID Trim Hi
Sets the maximum positive value that
is added to a PID reference when PID
trim is used.
Parameter Number 230
Access Rule GET/SET
Data Type UINT
Group Drive Advanced Setup
Units 0.1
Minimum Value 0.0
Maximum Value 400.0
Default Value 60.0
PID Trim Lo
Sets the minimum positive value that
is added to a PID reference when PID
trim is used.
Parameter Number 231
Access Rule GET/SET
Data Type UINT
Group Drive Advanced Setup
Units 0.1
Minimum Value 0.0
Maximum Value 400.0
Default Value 0.1