Rockwell Automation 284E ArmorStart with EtherNet/IP - User Manual - Manual (Page 156)

156 Rockwell Automation Publication 280E-UM001B-EN-P – July 2012
Chapter 7 Bulletin 280E/281E/284E Programmable Parameters
Fault 1 Code
A code that represents the drive fault.
The code will appear in this parameter
as the most recent fault that has
occurred. (Refer to
Internal Drive
Faults in Chapter 10 for more
information).
Parameter Number 107
Access Rule GET
Data Type UINT
Group Drive Display
Units —
Minimum Value F2
Maximum Value F122
Default Value Read Only
Fault 2 Code
A code that represents a drive fault.
The code will appear in this parameter
as the second most recent fault that
has occurred.
Parameter Number 108
Access Rule GET
Data Type UINT
Group Drive Display
Units —
Minimum Value F2
Maximum Value F122
Default Value Read Only
Fault 3 Code
A code that represents a drive fault.
The code will appear in this parameter
as the third most recent fault that has
occurred.
Parameter Number 109
Access Rule GET
Data Type UINT
Group Drive Display
Units —
Minimum Value F2
Maximum Value F122
Default Value Read Only
Process Display
The output frequency scaled by the
process factor (Parameter 199).
Parameter Number 110
Related Parameter 101. 199
Access Rule GET
Data Type UINT
Group Drive Display
Units —
Minimum Value 0.00
Maximum Value 9999
Default Value Read Only