Rockwell Automation 284E ArmorStart with EtherNet/IP - User Manual - Manual (Page 81)

Rockwell Automation Publication 280E-UM001B-EN-P - July 2012 81
Adding an ArmorStart to RSLogix 5000 Chapter 5
5. Select the ArmorStart in your application and click OK.
6. The AOP is shown below. Enter a Name for this ArmorStart and an
Ethernet address. For this example, the Private Network setting will be
used. This should be set to match the IP address switch setting on the
ArmorStart. Then press OK.
Note: Refer to Configuring EtherNet/ IP Address in Chapter 4 to set an
IP address on the device.