Rockwell Automation 284E ArmorStart with EtherNet/IP - User Manual - Manual (Page 113)

Rockwell Automation Publication 280E-UM001B-EN-P – July 2012 113
Bulletin 280E/281E/284E Programmable Parameters Chapter 7
ArmorStart EtherNet/IP
Parameters Introduction
This chapter describes each programmable parameter and its function.
Parameter Programming
Each Distributed Motor Controller type will have a common set of parameters
followed by a set of parameters that pertain to the individual starter type.
Parameters 1
… 100 are common to all ArmorStarts
Bulletin 280E/281E Basic Status Group
IMPORTANT Parameter setting changes take effect immediately unless otherwise noted in the
parameter listing. These changes maybe immediate even during the "running" status.
Hdw Inputs
This parameter provides status of
hardware inputs.
Parameter Number 1
Access Rule GET
Data Type WORD
Group Basic Status
Units —
Minimum Value 0
Maximum Value 15
Default Value 0
Bit
Function
3 2 1 0
— — — X In0
— — X — In1
— X — — In2
X — — — In3