Rockwell Automation 284E ArmorStart with EtherNet/IP - User Manual - Manual (Page 313)

Rockwell Automation Publication 280E-UM001B-EN-P – July 2012 313
Using DeviceLogix Appendix C
15. Click file close. The program is not saved automatically. Fill in the
information on following window and accept changes. This saves the
program but has not been downloaded in the product.
16. The last step is to enable the logic via the drop down.
17. Click OK. To download the DeviceLogix program you must go on-line
with the PLC and allow the download. Ensure that the PLC is in the
Program position. If in any other position, the download will not occur
and an error will be generated.
18. The ArmorStart is now programmed and the logic is Active.