Parameters tab, Online connection – Rockwell Automation 284E ArmorStart with EtherNet/IP - User Manual User Manual
Page 85
Rockwell Automation Publication 280E-UM001B-EN-P - July 2012
85
Adding an ArmorStart to RSLogix 5000 Chapter 5
Parameters Tab
Click on the Parameters tab to display the following:
The parameters are divided into groups based on the type of ArmorStart. By
clicking in the Group drop down menu you can choose which parameter group is
displayed. When the Parameters tab is selected, the tab defaults to the Drive
Setup (Bulletin 284E) or Starter Setup (Bulletin 280E) groups depending on the
ArmorStart. These Setup groups are the minimum required parameters to get the
ArmorStart running.
After this parameter group has been set, the next time that the Parameters tab is
opened, all of the parameters will be shown and the tab will no longer default to
the setup groups.
Online Connection
Now that the offline connection settings have been set, connect to the
ArmorStart and review the last five AOP tabs.
Note:
If you are using a Cat. No. 1756-ENBT Ethernet module to communicate with
the PLC, verify that you have updated the module’s firmware to Revision 6.001 or
later. The latest firmware can be found