Rockwell Automation 284E ArmorStart with EtherNet/IP - User Manual - Manual (Page 279)

Rockwell Automation Publication 280E-UM001B-EN-P – July 2012 279
CIP Information Appendix B
Identity Object CLASS CODE 0x0001
The following class attributes are supported for the Identity Object:
Up to nine instances (Instance 1…9) of the Identity Object will be supported.
The following table shows what each instance will represent, and what the
revision attribute will report:
➊ These instance numbers will assume the next available instance base on the unit configuration. (If the unit is a DOL (No Drive) and
there is a MCB Daughter board present it’s instance number will be 7.)
Attribute ID Access Rule Name Data Type Value
1 Get Revision UINT 1
2 Get Max Instance UINT 9
Instance Name Revision Attribute
1 EtherNet/IP Module The firmware rev of the EtherNet/IP board main firmware.
2 EtherNet/IP Boot The firmware rev of the EtherNet/IP board boot firmware.
3 FPGA The rev of the FPGA program
4 Control Module
A coded revision reflecting the revision attribute of the other various identity object
instances (excluding boot code). Major revisions are coded as: 0SSSMMMM
• 0 = reserved by DeviceNet
• SSS = Revision of Soft-start or inverter. Initial release = 0; We will be limited
to support for 8 major revisions.
• MMMM = Revision of Main ArmorStart board. Initial release = 1; We will be
limited to support for 15 major revisions.
5
Main Control Board
Operating System
The firmware rev of the Main ArmorStart board OS stored in flash memory.
6 Main Control Board Boot Code The firmware rev of the Main ArmorStart board boot code stored in flash memory.
7 The Internal PF 40 Inverter The firmware rev of the Inverter as read from the RS485 connection.
8 ➊ MCB IIC Daughter Board The firmware rev of the MCB IIC Daughter Board
9 ➊ BASE IIC Daughter Board The firmware rev of the Base IIC Daughter Board
IMPORTANT Attempts access Attribute 10 of all DeviceNet Main Control Board instances will be
blocked. If Attribute 10 (Heartbeat Interval) is accessed, an “Attribute Not Supported”
error will be generated.