Rockwell Automation 284E ArmorStart with EtherNet/IP - User Manual User Manual
Page 311
Rockwell Automation Publication 280E-UM001B-EN-P – July 2012
311
Using DeviceLogix Appendix C
7.
Move the mouse cursor toward the Set input of the reset function. A line
will follow the cursor. When a connection can be made, the tip of the RSL
function will also turn green. Click the on Input and the line will be drawn
from In 0 to the Set Input of the reset function.
Note:
If this was not a valid connection, one of the pin tips would have turned
red rather than green. Left double clicking on the unused portion of the grid or
pressing the “Esc” key at any time will cancel the connection process.
8.
From the toolbar, Click on the “Bit Input” button and select In 1 from the
pull-down menu. This is the remote stop button based on the example I/O
table.
9.
Place the input to the left of the reset function.
10.
Connect the input to the reset input of the reset function.