Rockwell Automation 284E ArmorStart with EtherNet/IP - User Manual - Manual (Page 224)

224 Rockwell Automation Publication 280E-UM001B-EN-P - July 2012
Chapter 10 Troubleshooting
Bulletin 280E/281E
Troubleshooting The following flowchart for Bulletin 280E/281E units is provided to aid in quick
troubleshooting.
Figure 82 - Bulletin 280E/281E Control Module LED Status
Bulletin 284E
Troubleshooting Fault Definitions
Some of the Bulletin 284E ArmorStart Distributed Motor Controller faults are
detected by the internal hardware of the ArmorStart, while others are detected by
the internal drive. For internal drive faults, the internal hardware of the
ArmorStart simply polls the drive for the existence of faults and reports the fault
state. No fault latching is done by the internal hardware of the ArmorStart for
these faults. The PrFlt ResetMode parameter (Parameter 23) determines the
Auto Resettability of only the faults that are detected on the main control board.
The Auto Resettability of the faults that are detected in the internal drive is
controlled by internal drive parameters, refer to
Table 38 . The following
flowchart for Bulletin 284E units is provided to aid in quick troubleshooting.
ATTENTION: An incorrectly applied or installed drive can result in component damage
or a reduction in product life. Wiring or application errors, such as undersizing of the
motor, incorrect or inadequate AC supply, or excessive ambient temperatures may result
in malfunction of the system.
Faulted Display
Motor will not
Start
See
Table 40
See
Table 30
Fault
LED
Network
LED
Yes
No
See
Table 34