Rockwell Automation 284E ArmorStart with EtherNet/IP - User Manual - Manual (Page 242)

242 Rockwell Automation Publication 280E-UM001B-EN-P - July 2012
Chapter 11 Specifications for EtherNet/IP
Output Ratings – Sourced
from Control Circuit (A1/A2)
Rated Operation Voltage 26.4V DC
Rate Insulation Voltage 250V
Dielectric Withstand 1500V AC (UL) 2000V AC (IEC)
Operating Frequency Solid state sourcing output
Type of Current 24V DC
Conventional Thermal Current Ith 0.5 A each, 1 A max. combined
Peak Output Current Current limited 2-8 amps (5 amps nominal) @ 24V DC
Type of Contacts Normally open (N.O.)
Number of Contacts 2
Load Types Resistive or light inductive
Surge Suppression Integrated diode, clamps @ 35V DC
Thermo-Protection Integrated short circuit and over current protection
Maximum Cycle Rate 30 operations/minute capacitive and inductive loads
Maximum Blocking Voltage 35V DC
Maximum On-State Voltage @
Maximum Output
1.5V DC
Maximum Off-State Leakage Current 10 μA
Device Level Ring (DLR)
Beacon-based performance including IEEE 1588 end to end transparent clock
Fault Recovery Ring recovery time is less than 3 ms for a 50 node network
Ethernet Port
EtherNet Receptacles 2 D-coded, 4-pin female M12 connectors
Ports Embedded switch with 2 ports
IP Address DHCP enabled by default
DHCP Timeout 30 s
Communication Rate 10/100 Mbs with auto negotiate half duplex and full duplex
Data
• Transported over both TCP and UDP
• Min. of 500 I/O packets/second (pps)
• Supports up to 150 concurrent TCP sockets
Web Server
Embedded web server
Security Login and password configurable
E-mail Support Simple Mail Transfer Protocol (SMTP)
Configuration Status, diagnostics, and configuration tabs
Device Connections
Supports scheduled (Class 1) and unscheduled (Class 3 & UCMM) connections
6 - Class 3 connections are supported simultaneously
Supports up to 2 Class 1 CIP connections [Exclusive owner (data) or listen-only]. One connection per PLC.
Listen only connection requires a data connection to be established.
Class 1 Connection API: 2…3200 ms, Class 3 Connection API: 100…10 000 ms
20 ms default (2 ms minimum)
3 concurrent Encapsulation sessions
TCP port supports 5 concurrent incoming connections
UL/NEMA IEC